SINTLAC SINTETIC GLOSS ENAMEL LT. 0,75 WHITE

0 out of 5
SKU: D8608000750 Categories: , ,

12,50 

21 in stock

Description

Gloss enamel finish, easy to apply, providing good coverage for superstructure of boats and for maintenace works on board of fishing boats and all kinds of boats in general. Recommended application only above the waterline. It is traded at a competitive price offering a good quality finish. Available in a wide range of colours as per colour card.

 

SURFACE PREPARATION AND APPLICATION SYSTEM

Bare  steel. 

The substrate should be clean, dry, well degreased and free from any  trace of corrosion or calamine. Apply 1-2 coats of EVIOX CROMOMINIO  primer and let dry. Overcoat with 2 coats of SINTLAC finish allowing  16-24 hours between coats.

Bare Wood. Apply 1-2 coats of EVIOX CROMOMINIO primer or apply  2 coats direct of SINTLAC finish allowing the required  waiting period between coats.

Previously  Painted Surfaces:

– If the old paint is in bad conditions, the loose  or powdery parts should be mechanically removed. Clean  the surface with suitable detergent material and rinse. Let dry thoroughly. Where necessary  use SINTOFILLER to fill up and make even any surface irregularity, sand and follow up the directions as per Bare Wood desciberd above

– If the old paint is in good condition  and it only needs a topcoat because it is dull or dirty but with the underneath coatings still well fixed to the substrate (with no cracks or bubbles), clean, sandpaper and apply 1-2 coats of SINTLAC finish allowing the required waiting period  between coats.

NOTE: Dilution rates and drying  times must be considered only indicative, mainly related to a temperature of 20 ° C (68°F)  and may vary according to prevailing temperature, in presence of particular weather conditions or depending on application procedures.

 

  • Application Brush-Roller-Spray
  • Brush-Roller 5% Thinner 107 or 109
  • Spray 5-10% Thinner 900 or 107
  • Touch dry 2-4 h (20°c)
  • Recoat time 24 h (20°c)
  • Application temperature Between +10 C and +40 C
  • Relevant humidity Less than 80%
  • Dry film thickness advised 40 microns per coat
  • Theoret. coverage m2/Lt 10

Additional information

Weight 1 kg

Reviews

There are no reviews yet.

Be the first to review “SINTLAC SINTETIC GLOSS ENAMEL LT. 0,75 WHITE”

Your email address will not be published. Required fields are marked *

SINTLAC SINTETIC GLOSS ENAMEL LT. 0,75 WHITE
12,50